Napco Security Technologies GEM-K2AS Manuel d'utilisateur télécharger pdf (Page 26)

PROGRAMMING (OPTIONAL)

5. Enter the new User Code using the

number buttons. If an old code is

displayed, simply program over it.

Important: To erase the unused

digit(s) of the previous code, press

G 0.

Note: Pressing

R again will dis-

play non-programmable "OPTion" and

"ACCess" screens. Do not attempt to

program these screens as the entries

will not be saved.

6. Press

to save the code in mem-

ory. Repeat steps 3-6 for each user.

Note: To void a code, blank out each

digit by pressing

G 0, then

press the Save (

) button.

Note: Duplicate Codes are not allowed;

therefore a duplicate Code entered in

the LCD Window will erase when

pressed.

To Program User Codes

1. Using Number buttons,

enter User Number

2. Press

3. Using number buttons,

enter User Code of up to

6 digits.

4. Press

to save.

5. Press

to Exit Pro-

gram Mode.

Programming User Codes

User01

Note: Press

G, 0 to clear

character at cursor.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 35 36

Pas de commentaire

Napco Security Technologies GEM-K2AS Manuel d'utilisateur Page 26