Napco Security Technologies GEM-K1CA Manuel d'utilisateur télécharger pdf (Page 35)

SYSTEM TROUBLE ERROR CODES

Trouble

Indication

System Trouble

Condition

Action

E10-NN

Keypad Response Failure Call installing company for service.

E11-NN

Keypad Tamper A keypad has been removed from the wall. Call installing company for service if

problem cannot be repaired.

E12-NN

Expansion Zone Module

Response Failure

Call installing company for service.

E13-NN

Expansion Module Tamper The cover has been removed from a zone expansion module. A problem has been

detected with an Expansion Module. Call installing company for service.

E14-NN

Relay Board Response Fail-

ure

NN= Relay Board Number. Call installing company for service.

E15-NN

RF Transmitter Tamper Wireless Transmitter Tamper Cover removed. NN=Transmitter Number. Call installing

company for service.

E16-NN

Wireless Receiver Jam A problem has been detected with the wireless receiver. Call installing company for

service.

E17-NN

Receiver Tamper Condition Call installing company for service.

E18-NN

KeyFob Transmitter Low

Battery

The batteries (2) in the wireless KeyFob transmitter indicated are low and should be

replaced. The replacement battery is the #386 watch battery.

Warning: Replace batteries only with the same type as specified above. Use of another

battery may present a risk of fire or explosion. Do not recharge or disassemble battery, or

dispose of in fire.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40

Pas de commentaire

Napco Security Technologies GEM-K1CA Manuel d'utilisateur Page 35